-  800/900 Series Operator  -

900.jpg

The 800/900 Series comes in three different styles and 2 different voltages.

800/900 Standard Operator. This operator can be used for most applications. The gate leaf cannot exceed 16 feet. It will open a gate with a 90 degree swing in 12 seconds and close the gate in 14 seconds.

800/900 Slow Speed. This slow-speed operator should be used in applications where the gate is over 16 feet, the gate travels up or down a hill, and/or the gate frame will flex when it reaches the end of travel. It will open a gate with a 90 degree swing in 17 seconds and close the gate in 20 seconds.

800/900 Long. This operator is normally used in applications where the gate column is too large in diameter for normal mounting dimensions or in applications where an insert cannot be mounted in the column. It will open a gate with a 90 degree swing in 12 seconds and close the gate in 14 seconds.

The 800 is a 220 VAC Single Phase.

The 900 is a 115 VAC Single Phase.

Hydraulic locks in both the open and closed positions. For gates greater than 12 feet in length, electric locks are recommended.

 

In some states and cities (in case of a power outage), the gate must be able to be pushed open by the fire ore emergency vehicle. We can take out the hydraulic check valve in the closed position. You must then use an electric lock to keep the gate closed.

With the operator mounted inside the property, the operator can be installed to swing inward or outward. Most mechanical operators must be mounted on the side the gate will swing toward.

413 South Linden St, Lusk, WY 82225