top of page

-  Products  -

We have operators for virtually any swing or horizontal slide application. Most of our products are UL-325 and ETL certified. All hydraulic gate operators in the Eliminator Series (pictured below) need no positive stops. The operator automatically slows the gate during the final 5 degrees (3/4") of motion.

-  Sliding Gate Demo Video  -

Hydraulic Operators


500 Series Operator

Hydraulic System

The 500 Series is a residential swing gate operator. As a light-duty operator, it should be subject to no more than 60 cycles per hour.


800/900 Long Series Operator

Hydraulic System

This operator is normally used in applications where the gate column is too large in diameter for normal mounting dimensions or in applications where an insert cannot be mounted in the column.


600 Series Operator

Hydraulic System

The 600 Series is a residential and medium-duty commercial operator for applications that require 100 cycles per hour or less.



Hydraulic System

The Byan Systems In-Ground 1100 Hydraulic Swing Gate Operators are designed to provide you with the best in security access while being virtually invisible.


800/900 Series Operator

Hydraulic System

800/900 Standard Operator. This operator can be used for most applications. The gate leaf cannot exceed 16 feet. It will open a gate with a 90 degree swing in 12 seconds and close the gate in 14 seconds.


Hydraulic Swing Gate Operators

Hydraulic System

Providing the highest quality automated
gates since 1991, Byan Systems, Inc. is
a manufacturer of swing gate, slide
operators and access control products.

Enclosures and Processors


Pre-Wired Enclosures

Enclosures and Processors

We offer 3 different standard enclosures for your microprocessor. Other sizes and specifications can be created by special order.


G2M+ Industrial Control
Board and Pre-wire

Enclosures and Processors

This board is suitable for single-phase
motors and can drive up to two different
motors at once.


Q2MNB Board

Enclosures and Processors

Control panel powered at 230V with integrated radio designed to control 2 motors (electromechanical or hydraulic). Programming allows different offset times in opening and closing

Slider Series


M4 Electro-Mechanical Slide Operator


The Byan Systems M4 is a rack and pinion electro-mechanical slide operator. This operator is capable of movement,
allowing it to follow the terrain.

bottom of page